3.9.2015

Kaaret..."Framework"

Ruissalon telakalla on aika mennyt nopeasti rungon sisäpuoliseen viimeistelyyn. 

- Muutaman mallikaaren kohdalla olevat kaaret asennettiin paikallaan 
- Viimeiset niitit lyötiin runkolautoihin
- Pohjatukit pultattiin kölipuuhun 
- Kaarien sisäpuolinen muoto höylättiin
- Runkolaudoista on etsitty isot oksat jotka pitää porata pois ja tulpata

Tärkein tehtävä on ollut ylimmän runkolaudan muotoilu ja tässä on ollut eduksi vanhan veistämön avaruus eli venettä on voinut katsoa jonkin matkan päästä jotta voi varmistua kauniista "ketkasta".

-----------------------------------------------------------------------------------------------------------------------------
Last six weeks has been spent on finishing touches inside the hull:

- Couple frames had to be built because the temp.frames had been too close to allow building them at an earlier stage
- There were also a few rivets that needed to be fastened
- The lowest part of the frames "Floor ?" was bolted to the keel
- The frames were shaped to match each others
- Large knobs on the hull planks were drilled out and plugged (for safety)

The most important job was to shape the sheer line on the last hull plank. It was very useful to be in this large workshop for that purpose as it allowed taking a few steps back to determine the final shape. The end result is beautiful !!




Veneen ympärille rakennettiin kävelysilta työskentelyn helpottamiseksi.

A wooden (of course) scaffold was built around the boat to make it easier to work close to the boat.



Hiomista riittää... There was a lot of planing and shaping to be done...



Kaarissa on kauniit muodot ja tietenkin materiaalivahvuutta ja lujuutta ei saa unohtaa.

The frames look very nice but the most important thing is that they are sturdy and thick as they were on these old freight boats



18 veistokaarta...18 hand carved frames !!




Sivukansien polviot on sovituksessa. Keulan polvio on myös paikallaan. Seuraavaksi vene siirretään takaisin veneveistäjän pihalle jossa sivukannet ja -sarjat tehdään ja vene kyllästetään.

The support brackets for the side-decks are lined up for final shaping. The bracket in the bow is shaped as well. In the next couple days the boat will be transported back to the boatbuilders place under a temp.shelter / building. This allows him to complete the hull and varnish the boat before the outfitting starts.

Ei kommentteja:

Lähetä kommentti